NiLight LED Light Bars



The Hella 500FF lamps located at the base of the A-pillars were overkill, not in terms of light, but in lamps, making eight lamps total on the front of the H3. I eliminated the 500s and installed a pari of NiLight 30W eight-inch light bars on the Garvin roof rack. 
I used the existing circuit for the previously installed Hellas when they were mounted on the roof rack. The wiring is insulated and runs down the A-pillars to the Blue Sea fuse block. 
The light bars offer a better area saturation while the LEDs are more efficient that the halogens. Their lower profile makes them less conspicuous as well. Build quality and materials are the same as the Cree lamps, best to replace the hardware with stainless.


Comments

Post a Comment

Popular posts from this blog

PCM of NC

Image
PCM Reprogram - July 19, 2014 Even though the H3's I5 produces a bit more power than the Montero's V6, it's sluggish at best with low RPM shifts with flat torque curves. I researched a number of mechanical mods to improve this (within my budget) and found that the most common - air intake upgrades, headers - yielded little change in performance and better fuel efficiency.  From various H3 user forums I heard about  PCM of North Carolina  and researched their service; they flash and reprogram the factory PCM (power-train control module) promising better throttle response and fuel efficiency, better shift points making better use of the torque curve, and more horsepower.  Sounds too good to be true, but having lived in North Carolina, it's been my experience to have never been disappointed with anything that comes from that state. So I made the order. I opted for their loaner program where they send a unit to replace the factory PCM while it's sent
Read more

Rear Door Mod

Image
While the above modification worked well to keep essentials handy, it encroached too far into the cargo space, since the overland gear packs in filling the space completely while securing the load.  The Fiskars ax has been relocated across the driver-side cargo area storage compartment and the MOLLE panel has been moved up above the rear-door utility shelf.  Now the packs clear the load when the door is closed, yet they're still accessible. Rear Door Utility Shelf Mod  One of our favorite interior modifications on the Montero was the addition of a utility shelf that provided a place for food prep. The H3's rear door stows the jack and hardware assembly behind a removable plastic panel, a perfect place to adapt a shelf to the rear door access cover versus adding one like what was done on the Montero . Looking at clearances and how the panel is engineered to fit into the plastic surround I decided to use one-quarter inch oak veneer for the shelf and
Read more

Garvin Roof Rack

Image
I considered two roof racks, a Gobi Stealth and the Garvin Sport roof rack, the latter being a third the the cost. While the Stealth would offer storage the length of the H3's greenhouse with a different construction, I'd be using a rack to stow recovery items and serve as a mount for an awning. While one of the laws of overlanding is the stuff you carry expands by 1.5 times to the available space, I won't be using the square footage of the Stealth and want to resist overloading the top of the rig. That's why I went with the Garvin. I researched to no avail to find how it mounts to an H3's existing rack system, so I thought I'd provide that illustration here. The front of the H3's rails have a plastic cap that clips into place, finishing the line of the rail to the front of the cab. This has a tab that when compressed and lifted, can be removed to access the rail. With this removed the cleats to which the feet of the Garvin rack mounts to can b
Read more